交底內容：
1．作業前，檢查各系統管理及接頭部分應無裂縫、松動和泄露現象，各緊固螺絲無松動，確認正常后方可啟動。
2．變壓路機前進、后退方向，應待滾輪停止?jié)L動后進行，嚴禁利用換向離合器做制動用。
   3．起振必須在壓路機行走后進行，停振必須在壓路機停車前進行，壓松散路基時，應先在不振情況下壓1~2遍，再用振動壓實。 
   4． 作業后壓路機應停放在堅實、平坦、安全的地方。
Cards on the table contents:
1. Work, check some of the systems management and joints should be no cracks, loose and leak phenomenon, no loosening the fastening screws, confirmed only after the normal start.
2. Variable roller forward and backward direction, wait until after the wheel stops rolling, non-use change do to the clutch brake.
   3. Walk from vibrating roller to be after, stop vibration to stop before the roller, pressure loose subgrade should be the first case in the weak pressure of 1 to 2 times, then vibration compaction.
   4. After the roller operation should be parked in a solid, flat, safe place.

前往下載